11
in a remodel
with
no REVEAL
With existing drywall
If applicable, install your 45° inside corners by using 4 of the 40 cove pieces that have
already been modied to be used as a cove piece as well as 45° inside corner.
8.
If you have a 45° outside corner,
a template on the side panel
of the box has been provided.
Trace your 45° outside corner on
to a piece of ½” plywood/OSB,
cut it out and then install.
At each corner of the room, measure and mark the wall down from the ceiling 15 ¼”.
Measure and mark the ceiling out from the wall 15 ¼”.
1.
Using your marks as a guide, snap a line (with your chalk line) on the wall and on the
ceiling around the entire perimeter of the room.
2.
Using a utility knife/wallboard saw, cut along the snap line and remove the drywall.
3.
At each corner of the room, measure and mark the wall down from the ceiling 11 ¼”
inches. Measure and mark the ceiling out from the wall 11 ¼”.
4.
Block in-between the wall studs and/or ceiling, if necessary, to suciently attach
the cove pieces. If building code requires you to re block, reference Step 11. In this
case, combining steps 2 and 11 can save time.
5.
Snap a line at the marks on the wall and along the ceiling around the entire
perimeter of the room using your chalk line.
6.
The 6 90° corners are reversible to t both inside and outside
corners. If you have an inside 90° corner, then the top halves
will are outward like the etchings of an arrow. If you have
an outside 90° corner, then the top halves will come to a point
like the head of an arrow.
90
o
inside corner
90
o
outside corner
Using a staple gun w/ 1” (or greater) staples/brads (PROs) or screw gun w/ 1”
(or greater) deck screws (DIYers) install your 90° inside and/or outside corners (right
angle) to align to your snap lines.
7.
Using a staple gun w/ 1” (or greater) staples/brads (PROs) or Screw Gun w/ 1” (or
greater) deck screws (DIYers) attach a cove piece butted to each side of each corner
(either touching the top of an inside corner or the bottom of an outside corner).
9.
Measure, mark and then attach all other cove pieces in between the butted cove
pieces on each corner no more than 16” O.C.
Helpful Tip: To space your cove pieces evenly between each corner visit www.archkit.
com/cove-spacing to watch our “How-To” video along with the mathematical formula.
10.
If necessary and/or according to code requirements, re block your Universal Cove Kit
in
between the studs along the perimeter.
11.
12
(16 pagine)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commenti su questo manuale